Industries
Trailers and transport equipment
Chassis, crossmembers, axle mounts, side rails, ramps. Long profiles, laser-cut up to 24 ft, with the holes already made.
What we produce for you
- Side rails and crossmembers in C-channel and HSS, up to 24 ft, with mounting holes at the cut.
- Axle and suspension mounts, cut and welded as sub-assemblies.
- Ramps and decks in tube and sheet, ready for galvanizing.
- Fender, light and tank brackets, in repeatable lots.
Trailer manufacturers in Montérégie and Centre-du-Québec have repetitive parts and lengths that few shops laser-cut. Our machine accepts 24 ft profiles.
Common materials, finishes and quantities
| Materials | Structural steel; HSS and C-channel up to 24 ft |
|---|---|
| Finishes | Galvanizing, epoxy paint |
| Typical quantities | Lots of 25 to 300 sub-assemblies |
What you send us to start
- A 3D file (STEP), a 2D drawing (DXF, DWG, PDF), or dimensioned photos of an existing part.
- The desired material and finish, or the intended use if you prefer we propose them.
- The quantity per lot and the frequency: once, every month, every season.
- The dimensions that must mate with something else. We treat them as critical.
How we work with this sector
- 01
DFM review
Our engineer reviews your parts for laser cutting and welding. Notches and holes move to the cut.
- 02
Approved prototype
A first part measured, adjusted with you, approved in writing.
- 03
Repeatable lots
Same program, same inspection, staggered deliveries on your schedule.