Industries
Security and technology
Enclosures, frames, equipment mounts. Consistency and documentation requirements above average. We meet them.
What we produce for you
- Equipment frames and bases in HSS and tube, with laser-positioned mounting holes.
- Sheet-metal enclosures and panels, cut, bent and powder-coated.
- Brackets and mounting plates in series, traceable by lot.
- Dimensional inspection report per lot, on request.
Giesecke+Devrient, a security technology multinational, is among our clients. One satisfied contact in a division opens the others.
Common materials, finishes and quantities
| Materials | Mild steel, stainless or aluminum depending on the enclosure |
|---|---|
| Finishes | Powder coating; plating on request |
| Typical quantities | Lots of 50 to 1,000 parts, traceable by lot |
What you send us to start
- A 3D file (STEP), a 2D drawing (DXF, DWG, PDF), or dimensioned photos of an existing part.
- The desired material and finish, or the intended use if you prefer we propose them.
- The quantity per lot and the frequency: once, every month, every season.
- The dimensions that must mate with something else. We treat them as critical.
How we work with this sector
- 01
DFM review
Our engineer reviews your parts for laser cutting and welding. Notches and holes move to the cut.
- 02
Approved prototype
A first part measured, adjusted with you, approved in writing.
- 03
Repeatable lots
Same program, same inspection, staggered deliveries on your schedule.