Industries
Retail displays, store fit-out and design furniture
Display structures, table legs, frames, serial shelving. Retail renews its fixtures in batches, over and over.
What we produce for you
- Display frames in square tube, clean TIG joints for visible surfaces.
- Table legs and structures in series, ready for powder coating or a raw finish.
- Laser-cut, bent sheet shelving, with special finishes.
- Sign frames and wall brackets, in lots per store.
PacoMetal built an oxidized-finish industrial shelf for Diptyque and a steel wine cellar for a Montréal restaurant. For a chain, we reproduce the same part for every location.
Common materials, finishes and quantities
| Materials | 1 × 1 and 2 × 2 square tube; 16 ga to 3/16 in sheet; stainless and brass for high-end work |
|---|---|
| Finishes | Powder coating, waxed raw finish, stabilized oxidized finish |
| Typical quantities | Lots of 5 to 100 parts per store |
What you send us to start
- A 3D file (STEP), a 2D drawing (DXF, DWG, PDF), or dimensioned photos of an existing part.
- The desired material and finish, or the intended use if you prefer we propose them.
- The quantity per lot and the frequency: once, every month, every season.
- The dimensions that must mate with something else. We treat them as critical.
How we work with this sector
- 01
DFM review
Our engineer reviews your parts for laser cutting and welding. Notches and holes move to the cut.
- 02
Approved prototype
A first part measured, adjusted with you, approved in writing.
- 03
Repeatable lots
Same program, same inspection, staggered deliveries on your schedule.