Industries
Food service and coffee equipment
Stainless frames, brackets and housings. A niche where cut and weld cleanliness shows, and pays.
What we produce for you
- Machine frames in stainless tube, clean TIG joints, without excessive discoloration.
- Brackets, shelves and housings in stainless sheet, laser-cut without burr.
- Perforated panels and grilles, repeated laser patterns.
- Small repeated runs, 20 to 200 parts, at your production pace.
MicroEspresso, an espresso machine manufacturer, has its stainless parts produced with us. See the case study.
Common materials, finishes and quantities
| Materials | 304 and 316 stainless; aluminum |
|---|---|
| Finishes | Brushed finish, passivation, no paint |
| Typical quantities | Small repeated runs of 20 to 200 parts |
What you send us to start
- A 3D file (STEP), a 2D drawing (DXF, DWG, PDF), or dimensioned photos of an existing part.
- The desired material and finish, or the intended use if you prefer we propose them.
- The quantity per lot and the frequency: once, every month, every season.
- The dimensions that must mate with something else. We treat them as critical.
How we work with this sector
- 01
DFM review
Our engineer reviews your parts for laser cutting and welding. Notches and holes move to the cut.
- 02
Approved prototype
A first part measured, adjusted with you, approved in writing.
- 03
Repeatable lots
Same program, same inspection, staggered deliveries on your schedule.