Industries
Gym and playground equipment
Racks, training machine frames, park modules. Tube, precise angles, and the same part a hundred times.
What we produce for you
- Racks and cages in 3 × 3 and 2 × 3 HSS, adjustment holes laser-positioned at a constant pitch.
- Training machine frames in tube, coped joints made at the cut.
- Play modules and structures in round tube, galvanized then powder-coated.
- Brackets, plates and fasteners in sheet, cut and bent.
The adjustment holes of a rack must be identical from one upright to the next. On a tube laser, the pitch is programmed once and reproduced on every part.
Common materials, finishes and quantities
| Materials | HSS 11 ga to 3/16 in; round tube |
|---|---|
| Finishes | Textured powder coating; galvanizing for parks |
| Typical quantities | Lots of 20 to 500 racks or modules |
What you send us to start
- A 3D file (STEP), a 2D drawing (DXF, DWG, PDF), or dimensioned photos of an existing part.
- The desired material and finish, or the intended use if you prefer we propose them.
- The quantity per lot and the frequency: once, every month, every season.
- The dimensions that must mate with something else. We treat them as critical.
How we work with this sector
- 01
DFM review
Our engineer reviews your parts for laser cutting and welding. Notches and holes move to the cut.
- 02
Approved prototype
A first part measured, adjusted with you, approved in writing.
- 03
Repeatable lots
Same program, same inspection, staggered deliveries on your schedule.